Improve company productivity with a Business Account.Sign Up

x
?
Solved

EIGRP ROUTE PRIORITY

Posted on 2006-11-09
4
Medium Priority
?
941 Views
Last Modified: 2010-05-19
If I have two routes to a remote office, A & B.

How can I force EIGRP to use route A as a primary route, and only use route B in
case of overload or breakdown of route A?

Thank You,
vreyesii
0
Comment
Question by:vreyesii
  • 2
  • 2
4 Comments
 
LVL 43

Accepted Solution

by:
JFrederick29 earned 2000 total points
ID: 17907943
You can either lower the bandwidth or increase the delay on the "backup" interface to increase it's metric in EIGRP.
0
 

Author Comment

by:vreyesii
ID: 17907970
How do I increase the delay?

0
 
LVL 43

Expert Comment

by:JFrederick29
ID: 17908401
Use the "delay" command:

interface <type/number>
delay 2000   <--a higher value than what is configured.
0
 

Author Comment

by:vreyesii
ID: 17908673
Thank You

vreyesii
0

Featured Post

Free Tool: IP Lookup

Get more info about an IP address or domain name, such as organization, abuse contacts and geolocation.

One of a set of tools we are providing to everyone as a way of saying thank you for being a part of the community.

Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

579 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question