if i have 4 switch 3950 connect to distrbution switch then connect to cisco router 2800 then to pix firewall 525
mangement ip of the first switch is 172.16.40.4 and for second switch is 172.16.40.5 and 172.16.30.5 and 172.16.20.5
network of first switch is 172.16.14.0
network for second switch is 172.16.13.0
network for 3 switch is 172.16.12.0
network for 4 switch is 172.16.11.0
i use nat in pix firewall
how i can deny all user from telnet to the switch 172.16.40.4 and 172.16.40.5
and accept to all user to telnet to switch 172.16.20.5 and 172.16.30.50
i want only IP 172.16.14.30 to enable to telnet to all the first two switch
If you use NetScaler you will want to see these guides. The NetScaler How To Guides show administrators how to get NetScaler up and configured by providing instructions for common scenarios and some not so common ones.
Even if you have implemented a Mobile Device Management solution company wide, it is a good idea to make sure you are taking into account all of the major risks to your electronic protected health information (ePHI).
Data center, now-a-days, is referred as the home of all the advanced technologies. In-fact, most of the businesses are now establishing their entire organizational structure around the IT capabilities.
In this tutorial you'll learn about bandwidth monitoring with flows and packet sniffing with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg).
If you're interested in additional methods for monitoring bandwidt…