Solved

Cannot reset password -Netgear mr814v2

Posted on 2006-11-12
1
3,791 Views
Last Modified: 2011-10-03
I can get to the login prompt and try admin and password for the credentials but stll cannot access the router. I tried resetting back to factory defaults via the reset button, but I still cannot get in. Any suggestions?
0
Comment
Question by:VConnick
1 Comment
 
LVL 8

Accepted Solution

by:
saw830 earned 125 total points
ID: 17926864
Hi VConnick,

Here's some documentation on the device:
http://kbserver.netgear.com/kb_web_files/N100651.asp

It says that the username is admin and the password will be either password or 1234.

Note the reset instructions farther down the page.

Have you tried all of this already?

Hope this helps,
Alan
0

Featured Post

Networking for the Cloud Era

Join Microsoft and Riverbed for a discussion and demonstration of enhancements to SteelConnect:
-One-click orchestration and cloud connectivity in Azure environments
-Tight integration of SD-WAN and WAN optimization capabilities
-Scalability and resiliency equal to a data center

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
How to set DHCPv6 options on a Sonicwall? 13 176
Local DNS and Home Routers 4 46
unable to set full duplex 100 on WAN interface 11 63
Configure BGP 22 12
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

860 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question