mjmarlow
asked on
Cisco PIX: How to change translation rule
Hi,
I have PIX 506e. I added a load balancer (.10) to my network and need to direct HTTPS traffic to it, instead of the .36 address it is currently configured map to. How do i go about this?
Currently there is a static NAT rule listed in the [Translation Rules] tab
[Original]
inside / xxx.xxx.xxx.36 Port: 443/tcp
[Translated]
outside interface IP Port: 443/tcp
[Options]
DNS rewrite No, Max conn Unlimited, Embryonic Unlimited, Random Seq. Yes.
Thanks for any help!
Mark
I have PIX 506e. I added a load balancer (.10) to my network and need to direct HTTPS traffic to it, instead of the .36 address it is currently configured map to. How do i go about this?
Currently there is a static NAT rule listed in the [Translation Rules] tab
[Original]
inside / xxx.xxx.xxx.36 Port: 443/tcp
[Translated]
outside interface IP Port: 443/tcp
[Options]
DNS rewrite No, Max conn Unlimited, Embryonic Unlimited, Random Seq. Yes.
Thanks for any help!
Mark
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
There is an access rule that for the .36 address too.