?
Solved

site to site vpn

Posted on 2006-11-19
3
Medium Priority
?
190 Views
Last Modified: 2013-11-16
Hi  ,

I have created a site to site vpn . i want to access internet locally in both the location. so what is the command i have to give.
0
Comment
Question by:abey_varghese
  • 2
3 Comments
 
LVL 32

Accepted Solution

by:
rsivanandan earned 1500 total points
ID: 17974501
Assuming PIX;

For the site to site vpn, you would've configured which traffic should go through the tunnel using an access-list, something like;

access-list VPN permit ip <NetworkA> <Mask> <NetworkB> <Mask>

The above at the NetworkA PIX

access-list VPN permit ip <NetworkB> <Mask> <NetworkA> <Mask>

Cheers,
Rajesh

0
 

Author Comment

by:abey_varghese
ID: 18011539
yes i did the same. but when a guy is connected thrugh vpn, his ip is not natting. but when he connected to internet his ip will be natting. so this ip's got conflict ?
0
 
LVL 32

Expert Comment

by:rsivanandan
ID: 18059156
It is an improper nat configuration on the other side,I would believe.

Cheers,
Rajesh
0

Featured Post

What Kind of Coding Program is Right for You?

There are many ways to learn to code these days. From coding bootcamps like Flatiron School to online courses to totally free beginner resources. The best way to learn to code depends on many factors, but the most important one is you. See what course is best for you.

Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

Join & Write a Comment

If you’re involved with your company’s wide area network (WAN), you’ve probably heard about SD-WANs. They’re the “boy wonder” of networking, ostensibly allowing companies to replace expensive MPLS lines with low-cost Internet access. But, are they …
LinkedIn blogging is great for networking, building up an audience, and expanding your influence as well. However, if you want to achieve these results, you need to work really hard to make your post worth liking and sharing. Here are 4 tips that ca…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
In this brief tutorial Pawel from AdRem Software explains how you can quickly find out which services are running on your network, or what are the IP addresses of servers responsible for each service. Software used is freeware NetCrunch Tools (https…

585 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question