Solved

QOS on Cisco 1600 series

Posted on 2006-11-22
2
645 Views
Last Modified: 2007-09-11
Hi,
I have never implemented QOS on Cisco router and I am looking for guidance and tips.
I have a Cisco 1605 router with one serial interface (connected to internet via frame relay) and one ethernet interface via which my clients access internet.
Traffic going through the router includes internet browsing, smtp/imap/pop3 and also voice/video (UDP).
I would like to have a simple configuration example of how I can give priority to UDP packets.
Can that be done on that router?
Shall I need to do it together with the framerelay provider?
Thanks in advance for guidance.
Regards,
Brian.
0
Comment
Question by:brianvanschellebeck
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 2

Accepted Solution

by:
shekharbasnet earned 125 total points
ID: 18001124
Brian,

interface serial x
ip add x.x,x.x
priority-group 1
!
priority-list 1 protocol ip high list 100
!
access-list 100 permit udp any any
!
!

Using the above rule, the highest priority will be given to UDP. but beware this traffic may usurp all the bandwidth resource leaving no bandwidth for the other traffic.

HTH
Shekhar Basnet
0
 

Author Comment

by:brianvanschellebeck
ID: 18007030
Unfortunately Cisco 1600 series does not support priority-group.
I shall get a 1700 series and implement this.
Thanks for your help.
0

Featured Post

Simple, centralized multimedia control

Watch and learn to see how ATEN provided an easy and effective way for three jointly-owned pubs to control the 60 televisions located across their three venues utilizing the ATEN Control System, Modular Matrix Switch and HDBaseT extenders.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In this tutorial I will show you with short command examples how to obtain a packet footprint of all traffic flowing thru your Juniper device running ScreenOS. I do not know the exact firmware requirement, but I think the fprofile command is availab…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses
Course of the Month7 days, 4 hours left to enroll

623 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question