troubleshooting Question

After expanding array and using diskpart to extend the volume the disk properties show the wrong size.

Avatar of stevegingell
stevegingell asked on
Windows Server 2003
6 Comments1 Solution418 ViewsLast Modified:
On a HP Proliant Server I added a 36GB drive to the Raid 5 array.  I did this using the HP Array Configuration Utility.  When the process had finished (after many days) I went to the disk management in Windows 2003 Server and saw that there was 36 GB of unallocated space.  I then installed diskpart for Windows 2003 Server and ran it to extend the volume.  I only have one volume (c:).  The diskpart process completed sucessfully.

However, I go into disk management now and the lower section shows the full volume size of 140GB, but the upper section (and in My Computer) shows 104GB.

I have tried rescanning the controller, updating drivers, etc.  I need to correct this problem.

ASKER CERTIFIED SOLUTION
Join our community to see this answer!
Unlock 1 Answer and 6 Comments.
Start Free Trial
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 6 Comments.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros