mbavisi
asked on
Cisco 3460 Ethernet port Line protol down!
hello,
I have a rather old cisco 3640 router with 3 ethernet ports --802.3 , when i connect it to a swith cor a laptop, i get a physical link, but line protocol down!
my configuration is very simple..
int eth 0/0
duplex full
arp arpa (tried it without this statemet too)
ip address x.x.x.x
Have no idea why it doesnt work!
I have a rather old cisco 3640 router with 3 ethernet ports --802.3 , when i connect it to a swith cor a laptop, i get a physical link, but line protocol down!
my configuration is very simple..
int eth 0/0
duplex full
arp arpa (tried it without this statemet too)
ip address x.x.x.x
Have no idea why it doesnt work!
Have you tried removing the "duplex full"? (no duplex full)
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Thanks for the comments guys, i was rather hoping people wouldnt post with 'straight vs cross' or 'duplex' comments, ive been a network engineer for 4 years--- Have found out its a dodgy ethernet port.