Need help with SNMP Cisco Pix 501 Configuration PART 5

I just got a great deal of help with a PIX 501 VPN Configuration with ACL addition via LRMOORE (Thanks For the Help As always): There are 2 commands of which I'm entering but the Firewall's will not accept said commands. Can someone help me resolve the issues with entering the 2 commands:

(config)# isakmp enable outside
ISAKMP cannot be enabled since fixup protocol esp-ike is enabled.  Please correct your configuration and re-issue the command


(config)# access-list MGMT permit udp host 192.***.***.*** host 65.***.***.*** eq snmp-trap
ERROR: invalid port snmp-trap
Usage:  [no] access-list compiled
[no] access-list deny-flow-max <n>
[no] access-list alert-interval <secs>
[no] access-list <id> object-group-search
[no] access-list <id> compiled
[no] access-list <id> [line <line-num>] remark <text>
[no] access-list <id> [line <line-num>] deny|permit
        <protocol>|object-group <protocol_obj_grp_id>
        <sip> <smask> | interface <if_name> | object-group <network_obj_grp_id>
        [<operator> <port> [<port>] | object-group <service_obj_grp_id>]
        <dip> <dmask> | interface <if_name> | object-group <network_obj_grp_id>
        [<operator> <port> [<port>] | object-group <service_obj_grp_id>]
        [log [disable|default] | [<level>] [interval <secs>]]
[no] access-list <id> [line <line-num>] deny|permit icmp
        <sip> <smask> | interface <if_name> | object-group <network_obj_grp_id>
        <dip> <dmask> | interface <if_name> | object-group <network_obj_grp_id>
        [<icmp_type> | object-group <icmp_type_obj_grp_id>]
        [log [disable|default] | [<level>] [interval <secs>]]
Restricted ACLs for route-map use:
[no] access-list <id> deny|permit {any | <prefix> <mask> | host <address>}