Solved

SonicWall Pro 200

Posted on 2007-03-17
2
2,673 Views
Last Modified: 2008-04-02
Hi,
Anybody know how to reset a SonicWall Pro 200 to it's defaults and what serial settings I need to connect to it ?
0
Comment
Question by:user727069
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 7

Accepted Solution

by:
jasonpaine earned 125 total points
ID: 18741763
Upload the new firmware to want to use from sonicwall's website. save current config.
Hold in the reset button for about 10 seconds, this puts you in safe mode. open web browser to 192.168.168.168
Upload boot to new firmware with factory defaults.

If using firmware 6.x


 Power down the appliance. Disconnect LAN and WAN ports
 Wait 30 seconds, press and hold the Reset button.
 While holding the reset button, power on the appliance.
 Continue to hold the Reset button until the Test light begins blinking.
 Once the Test light stops blinking and remains lit, release the Reset button.
 Reconnect to LAN port directly from host PC with cross-over cable (red cable that came with the SonicWALL) and reconnect WAN port.
 
0
 

Author Comment

by:user727069
ID: 18741824
Thanks!!!
0

Featured Post

Get 15 Days FREE Full-Featured Trial

Benefit from a mission critical IT monitoring with Monitis Premium or get it FREE for your entry level monitoring needs.
-Over 200,000 users
-More than 300,000 websites monitored
-Used in 197 countries
-Recommended by 98% of users

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

We sought a budget ($5,000) firewall solution that would provide all the performance we needed with no single point of failure.  Hosting a SAAS web application in our datacenter, it was critical that we find a way to keep connectivity up and inbound…
Network traffic routing plays key role in your network, if you have single site with heavy browsing or multiple sites, replicating important application data from your Primary Default Gateway ,you have to route your other network traffic from your p…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…
Monitoring a network: how to monitor network services and why? Michael Kulchisky, MCSE, MCSA, MCP, VTSP, VSP, CCSP outlines the philosophy behind service monitoring and why a handshake validation is critical in network monitoring. Software utilized …
Suggested Courses

631 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question