Still celebrating National IT Professionals Day with 3 months of free Premium Membership. Use Code ITDAY17

x
?
Solved

Cisco 3750 question.

Posted on 2007-03-26
1
Medium Priority
?
272 Views
Last Modified: 2010-04-17
HI there, I have afew questions regarding the cisco 3750 layer 3 switch and how they work.
-how do you configure it to route, can you assign an ip address to a vlan interface or a single switch port and have that be a routing interface? should they then show as connected interfaces in rotuing table. I've just done CCNA and they dont cover layer 3 switches, I have a couple to use but am unsure exactly how they work as a switch and a router.
-Thanks.
0
Comment
Question by:Tonywbb
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 20

Accepted Solution

by:
RPPreacher earned 500 total points
ID: 18799297
>how do you configure it to route

ip route {ip addr} {wildcard mask} {destination addr}

>can you assign an ip address to a vlan interface or a single switch port and have that be a routing interface?

Yes.

>should they then show as connected interfaces in rotuing table.

Yes.
0

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
Tired of waiting for your show or movie to load?  Are buffering issues a constant problem with your internet connection?  Check this article out to see if these simple adjustments are the solution for you.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

721 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question