Solved

cisco IOS image file name

Posted on 2007-03-28
4
1,331 Views
Last Modified: 2012-06-21
Hi,

What command can I use to see the cisco IOS image in a cisco device?  I want to see the file name.  Specifically I am talking about the boot image.
0
Comment
Question by:bryanlloydharris
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
  • 2
4 Comments
 
LVL 20

Expert Comment

by:RPPreacher
ID: 18807595
show version | incl flash
0
 
LVL 20

Accepted Solution

by:
RPPreacher earned 500 total points
ID: 18807599
actually

show version | incl image

is a little better but either will work
0
 
LVL 3

Author Comment

by:bryanlloydharris
ID: 18810746
Thanks, I will try it.
0
 
LVL 3

Author Comment

by:bryanlloydharris
ID: 18815247
It worked great, thanks again.
0

Featured Post

Get 15 Days FREE Full-Featured Trial

Benefit from a mission critical IT monitoring with Monitis Premium or get it FREE for your entry level monitoring needs.
-Over 200,000 users
-More than 300,000 websites monitored
-Used in 197 countries
-Recommended by 98% of users

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

695 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question