nourben
asked on
HP c-Class Blades and OA issue
In the Onborad Administrator under Device Bays, I have 3 blades, only one is showing as HP Proliant BL480c G1, the others are blank, but still can get to ILOs etc., everything is fine, just the name is missing.
FYI, I an new to Blades. Thanks.
FYI, I an new to Blades. Thanks.
Are the blades' names set in RBSU?
ASKER
Where to check, I have only
1.
2.
3. HP Proliant BL480c G1
1 and 2 should be the same as 3
1.
2.
3. HP Proliant BL480c G1
1 and 2 should be the same as 3
ASKER
This has been resolved by simply shutdown the server blade, remove it for few seconds and re-insert it while OA is open.
ASKER
Or change the Asset Name in the BIOS, that will fix it permanently.
So you set the names with RBSU?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.