Solved

What should be the average ping time across a pt2pt connection.

Posted on 2007-04-09
2
752 Views
Last Modified: 2008-02-01
What should be the average ping time across a pt2pt connection.  From one server to another?  My first hop hits the default gateway(1ms), then hits the end serial interface (10ms), then the server(10ms).  Is this normal times.
0
Comment
Question by:mkurtzhals
2 Comments
 

Accepted Solution

by:
Blake Stockslager earned 300 total points
ID: 18875853
It all depends on the distance of the circuit, for Point-to-Point circuits the latency is going to be much lower than a circuit going through carrier networks on the public internet.

A 10ms latency is extremely good for a point-to-point circuit as most are around 15ms to 25ms, but it is completely dependant on the distance and how your carrier has engineered your circuit.
0
 
LVL 22

Assisted Solution

by:WMIF
WMIF earned 200 total points
ID: 18879628
it depends on the type of connection.  i have a full mesh mpls network so its not exactly p2p.  i have a location in san diego that responds in 16ms and a location in miami that responds in 68ms.  these are both coming from los angeles.  i think your response times are just fine.
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

#Citrix #Citrix Netscaler #HTTP Compression #Load Balance
I recently attended Cisco Live! in Las Vegas, a conference that boasted over 28,000 techies in attendance, and a week of hands-on learning hosted by a solid partner with which Concerto goes to market.  Every year, Cisco displays cutting-edge technol…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.

705 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

18 Experts available now in Live!

Get 1:1 Help Now