Solved

RDP through PIX 506e to multiple terminal servers

Posted on 2007-04-11
4
387 Views
Last Modified: 2013-11-21
I have a pix 506e.  I have multiple terminal servers behind the 506e.  I need to port forward to different servers based wither on source IP address of the client PC or based on port from the client computer.
0
Comment
Question by:vpnsol
  • 3
4 Comments
 
LVL 29

Expert Comment

by:Alan Huseyin Kayahan
ID: 18891344
           
if you post your running config, we would write suitable commands. We dont know if you are using PAT or NAT. And also please specify terminal server IPs.
0
 

Author Comment

by:vpnsol
ID: 18891391
Because of my environment, I cannot post my terminal server info.  The inside addresses are 172.16.0.5 and 172.16.0.45  I am running PAT.  I am trying to port forward 3389 to 172.16.0.5.  that works.

I am trying to port forward port 4444 to 172.16.0.45.  htat doesn't
0
 
LVL 29

Expert Comment

by:Alan Huseyin Kayahan
ID: 18892613
       Hi vpnsol

static (inside,outside) tcp interface 4444 172.16.0.45 4444 netmask 255.255.255.255 0 0

Regards
0
 
LVL 29

Accepted Solution

by:
Alan Huseyin Kayahan earned 125 total points
ID: 18892784
       And you may have to add the acl for it

access-list outside_access_in permit tcp any host 172.16.0.45 eq 4444
access-group outside_access_in in interface outside
0

Featured Post

Complete VMware vSphere® ESX(i) & Hyper-V Backup

Capture your entire system, including the host, with patented disk imaging integrated with VMware VADP / Microsoft VSS and RCT. RTOs is as low as 15 seconds with Acronis Active Restore™. You can enjoy unlimited P2V/V2V migrations from any source (even from a different hypervisor)

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Tired of waiting for your show or movie to load?  Are buffering issues a constant problem with your internet connection?  Check this article out to see if these simple adjustments are the solution for you.
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Both in life and business – not all partnerships are created equal. As the demand for cloud services increases, so do the number of self-proclaimed cloud partners. Asking the right questions up front in the partnership, will enable both parties …

685 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question