[Okta Webinar] Learn how to a build a cloud-first strategyRegister Now


route, nat, ??

Posted on 2007-07-29
Medium Priority
Last Modified: 2010-05-18
I am having trouble with routing out to the intenet from ethernet0/0 from a host on ethernet0/1, though the router can ping google the desktop  cannot, any suggestions, should i use nat? and what statements should i use?
cisco 2611

Question by:kwouk79
1 Comment
LVL 32

Accepted Solution

rsivanandan earned 2000 total points
ID: 19590287
Yes you need to use nat; Since you've not given much information on the config or the ip addresses, I'll just port out how it is done.

int eth0/0
ip nat outside

int eth0/1
ip nat inside

ip nat inside source list 1 int eth0/0 overload

access-list 1 permit <Internal_IP> <Mask>

Note in the above access-list <Mask> would be the inverse of subnet mask.


Featured Post

Independent Software Vendors: We Want Your Opinion

We value your feedback.

Take our survey and automatically be enter to win anyone of the following:
Yeti Cooler, Amazon eGift Card, and Movie eGift Card!

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article will show how Aten was able to supply easy management and control for Artear's video walls and wide range display configurations of their newsroom.
In this article I will be showing you how to subnet the easiest way possible for IPv4 (Internet Protocol version 4). This article does not cover IPv6. Keep in mind that subnetting requires lots of practice and time.
Here's a very brief overview of the methods PRTG Network Monitor (https://www.paessler.com/prtg) offers for monitoring bandwidth, to help you decide which methods you´d like to investigate in more detail.  The methods are covered in more detail in o…
Michael from AdRem Software explains how to view the most utilized and worst performing nodes in your network, by accessing the Top Charts view in NetCrunch network monitor (https://www.adremsoft.com/). Top Charts is a view in which you can set seve…

834 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question