Dracoryu
asked on
Tungsten T3 Screen calibration
I have a Palm Tungsten T3, when the palm is in its small screen mode everything works fine, but when I extend the screen in the lower part of the screen, the screem it is with out calibration to the point that i can not manipulate the lower menu because the tip poins arouns half a centimeter above. When i run calibration for the screen this only works for small screen mode, it's any way to fix this problem?
ASKER
Ok, I already had the ROM Upgrade, and I applied the "DIA" patch files but the issue continues, it is possible it be a problem with the screen?
One way to check whether the digitizer is working properly is to doodle in the Note Pad application.
Does this work differently when the screen is expanded/collapsed? What about when it is half-open?
Does this work differently when the screen is expanded/collapsed? What about when it is half-open?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
Hi WVOz1970, exaclty that was what i was afraid hearing of, is there any forum documente where this were explained?
Thanks a lot.
Thanks a lot.
http://www.palm.com/us/support/downloads/tungstent3/t3_update.html
2) If that does not help, install the two screen-handling "DIA" patch files:
http://www.resco-net.com/palm/palmviewer_T3.asp
or
http://palmzone.net/downloads.php?lid=114
Let us know if that fixes your problem.