Solved

IP Details and Reboot Command

Posted on 2007-10-15
1
1,355 Views
Last Modified: 2012-05-05
Dear All,

I have been having to deal with an 1800 series Cisco ADSL router recently. I am pretty new to the hardware and have limited knowledge.

I can telnet into the device etc.

Can someone tell me the commands to display the ADSL IP Addresses (Public IPs) and the command to reboot the router

I can do with this urgently so I have awarded the points accordingly.
0
Comment
Question by:espoke
1 Comment
 
LVL 43

Accepted Solution

by:
JFrederick29 earned 500 total points
ID: 20078540
To display the IP addresses on the router:

show ip int brief  <--the ADSL is probably a dialer interface...

To reboot the router:

reload
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
How to use a IP block on cisco 877 3 44
Radius Debug Error 16 91
Home network with two AP's dropping WiFi connectivity 12 50
route-map permit with a number 1 19
This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

777 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question