netcomp
asked on
How to setup a new Cisco ASA 5520
We just purchased a Cisco ASA 5520. We are replacing our pix 515. How difficult is it to configure it? Is the Web interface to configure or we would have to use the Cisco ASDM to configure it. I remember that we used the consul port to connect to the Pix and use command line interface to configure them initially before using the graphical interface.
How do use the consul port to connect to the ASA. I dont rambler how it was done on the pix.
How do use the consul port to connect to the ASA. I dont rambler how it was done on the pix.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Same as the firewalls :)
ThanQ
Old Links Above
http://www.petenetlive.com/KB/Article/0000075.htm
also see
http://www.petenetlive.com/KB/Article/0000173.htm
http://www.petenetlive.com/KB/Article/0000075.htm
also see
http://www.petenetlive.com/KB/Article/0000173.htm
ASKER