troubleshooting Question

Stop console error messages?

Avatar of mdkcbjones
mdkcbjones asked on
RoutersNetworking Hardware-Other
2 Comments1 Solution1232 ViewsLast Modified:
I am setting up 2 Cisco 2600s back to back in a lab environment using 56K WIC cards.  The WICs are not fully configured and are giving me link up/down messages constantly.  It makes it very difficult to enter the config commands while the screen interrupts with these link up/down messages.  Is there a command to temporarily stop these messages and then re-enable them when I am done?  
ASKER CERTIFIED SOLUTION
wingatesl

Our community of experts have been thoroughly vetted for their expertise and industry experience.

Join our community to see this answer!
Unlock 1 Answer and 2 Comments.
Start Free Trial
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 2 Comments.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros