Solved

Sending Email through Dual Wan Router

Posted on 2007-11-14
2
228 Views
Last Modified: 2008-03-06
 We recently purchased and set up a Dual WAN router to be able to boost our internet bandwidth beyond what a single ISP can provide. Everything works fine except our outbound email is sometimes rejected, because the email will be routed through the new ISP and the IP that the recipient sees does not match the IP of our exchange server.  Is there a way to rectify this to be able to have a legitimate connection regardless of the route of the email through our router??  
0
Comment
Question by:VoodooFrog
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 104

Accepted Solution

by:
Sembee earned 500 total points
ID: 20280029
The way that I have been suggesting is that both connections are configured identically - so the same reverse DNS records and the A record points to both IP addresses. That will mean email comes in on both connections, but should also allow email to go out again.

Simon.
0
 

Author Comment

by:VoodooFrog
ID: 20281695
we found a setting on the router (buried under Misc Option) that allows us to forward SMTP (or other protocols) to a specific WAN.  
0

Featured Post

Best Practices: Disaster Recovery Testing

Besides backup, any IT division should have a disaster recovery plan. You will find a few tips below relating to the development of such a plan and to what issues one should pay special attention in the course of backup planning.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
When you try to share a printer , you may receive one of the following error messages. Error message when you use the Add Printer Wizard to share a printer: Windows could not share your printer. Operation could not be completed (Error 0x000006…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
In this tutorial you'll learn about bandwidth monitoring with flows and packet sniffing with our network monitoring solution PRTG Network Monitor (https://www.paessler.com/prtg). If you're interested in additional methods for monitoring bandwidt…

739 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question