Solved

Crystal report viewer cuts off half of the report when running it in my development environment

Posted on 2007-11-15
2
1,003 Views
Last Modified: 2013-11-26
I have a web site that uses cystal reports designed in visual studio 2005. When i run my web application on my development pc(localhost) and view the report when i run the application it shows only a 1/4 of the report in the reportviewer. When I publish the application to the web server where the Microsoft.Net framework 2 is present and the crystal report redistributables, then it works. Does it have something to do with a setting tht i have to set in the ide of visual studio, in the crystal report design viewer or is it something else. I have tried uninstalling crystal reports and re-installing it again. Thanks in advance
0
Comment
Question by:WalterRautenbach
2 Comments
 

Accepted Solution

by:
AdelKh earned 250 total points
Comment Utility
I had similar problem.
Try this, at the report design Go to Page Setup and in the printer options select "No Printer".
It is also a good advise to check your printer settings
0
 

Author Comment

by:WalterRautenbach
Comment Utility
Thanks. It is working.
0

Featured Post

Top 6 Sources for Identifying Threat Actor TTPs

Understanding your enemy is essential. These six sources will help you identify the most popular threat actor tactics, techniques, and procedures (TTPs).

Join & Write a Comment

IP addresses can be stored in a database in any of several ways.  These ways may vary based on the volume of the data.  I was dealing with quite a large amount of data for user authentication purpose, and needed a way to minimize the storage.   …
Hello everyone, Hope you find this as helpful as we did. We have on the company I work for an application built in Delphi V with Crystal Reports 8. We all know that Crystal & Delphi can be temperamental sometimes and the worst thing is, nearly…
Get a first impression of how PRTG looks and learn how it works.   This video is a short introduction to PRTG, as an initial overview or as a quick start for new PRTG users.
This video shows how to remove a single email address from the Outlook 2010 Auto Suggestion memory. NOTE: For Outlook 2016 and 2013 perform the exact same steps. Open a new email: Click the New email button in Outlook. Start typing the address: …

744 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

20 Experts available now in Live!

Get 1:1 Help Now