Solved

Cannot enable https on 1841 Router

Posted on 2007-11-19
3
608 Views
Last Modified: 2008-02-01
I am trying to enable https on my 1841 router using the command:
Router(config)# ip http secure-server
but I keep getting the error "% invalid input detected at '^' marker"
I do not understand what could be the problem.
0
Comment
Question by:AlanD_EMECO
  • 2
3 Comments
 
LVL 28

Expert Comment

by:batry_boy
ID: 20317556
Post the output of the "show ver" command from the CLI.

Have you tried to do it from the SDM?  (Security Device Manager)

I believe you can get to it under Configure-Additional Tasks-Router Access-Management Access and then checking the box for HTTPS at the bottom of that screen.
0
 

Author Comment

by:AlanD_EMECO
ID: 20317795
I have found the problem. The check box for HTTPS is greyed out in Additiopnal Tasks-Router Access-Management Access. Further research shoed that I do not have the IPSec ISO Image - hence no HTTPS.
0
 
LVL 28

Accepted Solution

by:
batry_boy earned 50 total points
ID: 20317804
Ah, makes sense...that was the reason I wanted you to post the output of the "show version" so as to verify if that was the case.  Good deal...glad you figured it out even if it doesn't get you to where you want to go, you don't have to scratch your head over it any more...;)
0

Featured Post

Highfive + Dolby Voice = No More Audio Complaints!

Poor audio quality is one of the top reasons people don’t use video conferencing. Get the crispest, clearest audio powered by Dolby Voice in every meeting. Highfive and Dolby Voice deliver the best video conferencing and audio experience for every meeting and every room.

Join & Write a Comment

Suggested Solutions

New Server 172.16.200.2  was moved from behind Router R2 f0/1 to behind router R1 int f/01 and has now address 172.16.100.2. But we want users still to be able to connected to it by old IP. How to do it ? We can used destination NAT (DNAT).  In DNAT…
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

757 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

18 Experts available now in Live!

Get 1:1 Help Now