Solved

How can I enable IP accounting on the cisco 3560 and 3750 switches?

Posted on 2007-11-20
1
5,897 Views
Last Modified: 2008-06-23
HI,

I found out that I cannot use Netflow or NBAR with cisco 3560 or 3750 switches.

I must be able to use IP accounting.  If so can you tell me the commands to enable it please, with any variables I might need to choose.

Thanks
0
Comment
Question by:mac326a
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
 
LVL 16

Accepted Solution

by:
2PiFL earned 500 total points
ID: 20319244
0

Featured Post

Forrester Webinar: xMatters Delivers 261% ROI

Guest speaker Dean Davison, Forrester Principal Consultant, explains how a Fortune 500 communication company using xMatters found these results: Achieved a 261% ROI, Experienced $753,280 in net present value benefits over 3 years and Reduced MTTR by 91% for tier 1 incidents.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
Limit traffic to specific Cisco port? 12 79
Password recovery 2960S 4 58
Router question 6 683
DVR Camera Security System Port Forwading 7 75
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
The Cisco RV042 router is a popular small network interfacing device that is often used as an internet gateway. Network administrators need to get at the management interface to make settings, change passwords, etc. This access is generally done usi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

751 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question