Print server says not configured for ethernet

Fiery x3e print server in a printer...I try to configure the ethernet section through the LED and it says ETHERNET NOT CONFIGURED.  How do I configure the ethernet in the print server so I can then configure the IP?

Kevin
Kevin SmithAsked:
Who is Participating?
 
michkoCommented:
The configuration guide at this link: http://usa.kyoceramita.com/KMAGlobalpub/jsp/Kyocera/download_center.jsp?prod=13007 has a large section on how to configure for a network, including "Performing setup from the control panel."  It should have everything you need.
0
 
Kevin SmithAuthor Commented:
Nothing helpful in the config guide, but the client had a different solution.  Points for taking a shot at it!  Thanks Michko!
0
 
michkoCommented:
Well thanks.  If my answer didn't have what you needed, I certainly wouldn't have objected to a request for refund of your points.  Thanks for the accept.  
0
Question has a verified solution.

Are you are experiencing a similar issue? Get a personalized answer when you ask a related question.

Have a better answer? Share it in a comment.

All Courses

From novice to tech pro — start learning today.