Solved

Configure Cisco 1720 router for use with Sonic Wall tz180.

Posted on 2007-11-26
2
574 Views
Last Modified: 2011-04-14
I need to configure a Cisco 1720 Router to be used with a Sonic Wall tz180.  According to Sonic Wall I need to configure this router in bridge mode.  How do I do that? Forgive me, but I need to no the commands from the command line.  If there is any other way that this could be configured please let me know as well.  Thanks for you time.  
0
Comment
Question by:dianthonym
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 50

Accepted Solution

by:
Don Johnston earned 125 total points
ID: 20352876
You didn't specify what type of interfaces you have, so I'll use ethernet 0 and serial 0 as an example.

config t
no ip routing
bridge 1 protocol ieee
int ethernet0
no ip address
bridge-group 1
int serial0
no ip address
bridge-group 1
0
 
LVL 6

Author Comment

by:dianthonym
ID: 20352994
Sorry,  I have FastEternet0 and serial0.  I will try those configs and let you know.  Thanks for the fast response.
0

Featured Post

Save the day with this special offer from ATEN!

Save 30% on the CV211 using promo code EXPERTS30 now through April 30th. The ATEN CV211 connects a laptop directly to any server allowing you instant access to perform data maintenance and local operations, for quick troubleshooting, updating, service and repair.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

739 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question