shanedixon
asked on
Cisco Multi Frame Relay Bundle of T1's at Site A to Multi sub interfaces on DS3 ATM at site B. How to configure for a bonded interface?
I have two Frame relay Lines at Site A into a 2621XM router. Site B has the other end of these going thru a Frame to ATM handoff from the telco to a DS3 ATM circuit. I know how to bundle T1 loops and Frame relays lines but not in this Frame to ATM conversion. Any ideas on how to proceed to bond these as one 2.xMB circuit?
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.