erolmurat
asked on
unlink table in Access 2007
I have a database on a network, the database is split and the tables are on s:/ drive and the front end is on C:/ drive. I need to add somemore onto the Table however this has a active link on it. How do I un link it so I can make updates to the table and then put the links back on again. The front end will not let me go into Design to add more firelds to the form - I'm unsure how to un link and make changes and re put the link back on again.
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
it would be good if I could do this from the front end as I cannot get into the back end of it to make any changes. It maybe on a drive where I have not got permission, i have to check with IT over this issue. It seems so easy to make changes but I cannot get into it to make them nor can I un link the database to do any changes. I have read the book and followed the steps even going into Link Manager screek where it show me a tick box, but this does nothing for me, I still cannot get into it to make any changes.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
I will have to check with the IT to find out, it seems strange to me that I cannot do any changes to it, after I have followed everybody who has contact me. Thank you for getting back to me and trying to help me out. Regards
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
DatabaseMX
Thank you for this information you have sent out to me, I will try and see if I have the permissions as I did not write this database and not sure I can make changes to it as its is on a Drive on our network. I will check with the IT deptment to see if I can make changes, Thank you again
Thank you for this information you have sent out to me, I will try and see if I have the permissions as I did not write this database and not sure I can make changes to it as its is on a Drive on our network. I will check with the IT deptment to see if I can make changes, Thank you again
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
ill give it a go and let you know, thanks again for your help
ASKER
Open in new window