James
asked on
How to get my 2800 to see new WIC Card
Setting up a new 2800.
In WIC 0 I installed a new VWIC2-2MFT-T1/E1.
Issued command> card type t1 0 0
No problem with that - I was able to bring these up in a multilink group.
I added another card in WIC 1.
Just a standard WIC-1DSU-T1
I can't get the router to see the card. card type command does not seem to be working?
I assumed since this is a standard T1 card, it would be seen automatically.
What am I missing?
Thanks!
In WIC 0 I installed a new VWIC2-2MFT-T1/E1.
Issued command> card type t1 0 0
No problem with that - I was able to bring these up in a multilink group.
I added another card in WIC 1.
Just a standard WIC-1DSU-T1
I can't get the router to see the card. card type command does not seem to be working?
I assumed since this is a standard T1 card, it would be seen automatically.
What am I missing?
Thanks!
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Lots of Boo's from the gallery for Cisco's non support of older WIC modules that folks have laying around...
ASKER
Ok - thanks!