looking for template for screw placement for a ATX and Eatx form factor

I building plexglass case for computer and need template for screw placement for the motherboard
tryed few times with the motherboard holes are not lining up right
Dan1965Asked:
Who is Participating?
 
MarkConnect With a Mentor Commented:
Your best bet would be to dismantle a computer case that has the capability to except both specifications and use the mounting panel to create your template, or use the mounting plate as the template.

You could also use a photocopier  to photo copy the mounting holes directly by laying the motherboard directly on it.
0
 
MarkConnect With a Mentor Commented:
Here is the ATX template measurements guide. Check Fig.3 for measurements
http://www.formfactors.org/developer%5Cspecs%5Catx2_1.pdf
0
 
Dan1965Author Commented:
mounting panel is is revited on main Computer case
0
Evaluating UTMs? Here's what you need to know!

Evaluating a UTM appliance and vendor can prove to be an overwhelming exercise.  How can you make sure that you're getting the security that your organization needs without breaking the bank? Check out our UTM Buyer's Guide for more information on what you should be looking for!

 
MarkConnect With a Mentor Commented:
Grind off the rivets, you are looking for a template which you can use over again. If you don't want to dismember a case then you will need to measure it out(you already tried that I believe) or the easiest, photocopy the motherboard.
0
 
MarkConnect With a Mentor Commented:
Drilling out the rivets will work even better
0
 
Dan1965Author Commented:
Thank You
0
All Courses

From novice to tech pro — start learning today.