bojojoe
asked on
accessing 2950t-48-si with CNA
When I try to access the switch with CNA 5.1, I enter the IP address of the switch 192.168.15.253, and I click connect, I get an error unable to connect. I open up options the protocol is http, the http port is 80 and the access mode is read write. I can access the switch with telnet. I have taken over this switch from somebody else. Is there a way I can tell which port I should be accessing instead of http 80.
thanks in advance
thanks in advance
please post here your cisco config
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.