What is the best way to choose one route over another in OSPF


Router A to Router B

Two t1's and wirless bridge connected to the the ethernet ports of each router.

So in essence-there are three paths from router A to router B

I would like to have traffice go over the Wireless, if the wireless fails-I would like to have
traffice transverse the t1's.

How would I configure ospf for this type of situation? Would I use cost?
Who is Participating?
I wear a lot of hats...

"The solutions and answers provided on Experts Exchange have been extremely helpful to me over the last few years. I wear a lot of hats - Developer, Database Administrator, Help Desk, etc., so I know a lot of things but not a lot about one thing. Experts Exchange gives me answers from people who do know a lot about one thing, in a easy to use platform." -Todd S.

you can configure ospf between two points.
but some boxes do limit equal cost multipath routes to 2. in this case you can aggregate two t1s into 1 with doubled capacity.
beside previous note ospf should work fine without any additional configuration (just configure networks and interfaces)

Experts Exchange Solution brought to you by

Your issues matter to us.

Facing a tech roadblock? Get the help and guidance you need from experienced professionals who care. Ask your question anytime, anywhere, with no hassle.

Start your 7-day free trial
It's more than this solution.Get answers and train to solve all your tech problems - anytime, anywhere.Try it for free Edge Out The Competitionfor your dream job with proven skills and certifications.Get started today Stand Outas the employee with proven skills.Start learning today for free Move Your Career Forwardwith certification training in the latest technologies.Start your trial today
Network Architecture

From novice to tech pro — start learning today.