Link to home
Start Free TrialLog in
Avatar of crandolphgrammar
crandolphgrammarFlag for United States of America

asked on

mds 9000 to mcdata fabric switches

I am working on a IBM H Blade server it has mds 9000 series fabric switches running to Mcdata they are in opt mode 1 the cisco switches can see the mcdata switches and the san beyond the can also see the q logice switche from the old blade center adn the fabric manager can see all switches and the old blades bt not the new ones, i can not see the new blades and the blades can not see the sans, any ideas would be appreaced.
ASKER CERTIFIED SOLUTION
Avatar of Duncan Meyers
Duncan Meyers
Flag of Australia image

Link to home
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
Start Free Trial
Avatar of crandolphgrammar

ASKER

i belive that all of this is done i have checked both switches conf file, when i go to the qlogic bios and scan for device it sees none, in the cisco fabric manger i can see all the devices in the fabric and all the device in the san from that manager but not from the blade.
Have you zoned the new servers so that they can see the  storage?
Points please!
meyersd,

Its up to the moderator, but just to explain why I chose Delete/No Refund.  Delete because it ended with the asker not getting things working after the initial suggestion.  Also, I wasn't seeing a value in committing it to the PAQ database.  No Refund because it ended with you asking a question the asker didn't respond to.

If you do believe that your comment should be accepted as the solution, please explain why.  Personally, I think it just helps the moderator make a more informed decision on how to close the question.  Thanks.
Thanks Cyclops3590,

The reason I raised it is that 99% of connectivity issues are fixed by applying the details of my first post; that is: put the different vendor's switches into compatibility mode, check that domain IDs are different then set identical ED_TOV and RA_TOV