troubleshooting Question

Proper trunk port setup

Avatar of NolanDorsett
NolanDorsett asked on
Network OperationsNetworkingRouters
1 Comment1 Solution599 ViewsLast Modified:
As you no most switch come configured with ports in dynamic mode and you have to put them in access mode if you want them to be.  What i want to know is when i run the switchport mode trunk command on both ends of the link should both ends be in dynamic mode or in access mode or it doesnt matter.  Also if oth ends are in dynamic will it automatically form a trunk link and if so is this because it recognizes the two end points are switch and not switch and pc.
ASKER CERTIFIED SOLUTION
Join our community to see this answer!
Unlock 1 Answer and 1 Comment.
Start Free Trial
Learn from the best

Network and collaborate with thousands of CTOs, CISOs, and IT Pros rooting for you and your success.

Andrew Hancock - VMware vExpert
See if this solution works for you by signing up for a 7 day free trial.
Unlock 1 Answer and 1 Comment.
Try for 7 days

”The time we save is the biggest benefit of E-E to our team. What could take multiple guys 2 hours or more each to find is accessed in around 15 minutes on Experts Exchange.

-Mike Kapnisakis, Warner Bros