Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people, just like you, are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
Solved

Make changes to the static route map

Posted on 2008-06-09
2
830 Views
Last Modified: 2012-06-27
I have this static route map set up.



ip nat inside source static 192.168.1.14 208.xx.xxx.162 route-map STATIC_RMAP
ip nat inside source static 192.168.1.13 208.xx.xxx.163 route-map STATIC_RMAP

ip nat inside source static 192.168.1.20 208.xx.xxx.168 route-map STATIC_RMAP

ip nat inside source static 192.168.1.21 208.xx.xxx.175 route-map STATIC_RMAP

ip nat inside source static 192.168.1.24 208.xx.xxx.178 route-map STATIC_RMAP


I would like to change the route map of internal 192.168.1.21 to 192.168.1.17 to point to 208.xx.xxx.175


0
Comment
Question by:DarITeam
2 Comments
 
LVL 16

Accepted Solution

by:
2PiFL earned 500 total points
ID: 21745851
Make sure you have a copy of your current config.

From an enable prompt:
#conf t
(config)#no ip nat inside source static 192.168.1.21 208.xx.xxx.175 route-map STATIC_RMAP
(config)#ip nat inside source static 192.168.1.17 208.xx.xxx.175 route-map STATIC_RMAP
(config)#exit
#wr mem
0
 

Author Comment

by:DarITeam
ID: 21746105
That worked thanks!
0

Featured Post

Connect further...control easier

With the ATEN CE624, you can now enjoy a high-quality visual experience powered by HDBaseT technology and the convenience of a single Cat6 cable to transmit uncompressed video with zero latency and multi-streaming for dual-view applications where remote access is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

This article is a guide to configure bridging on Cisco Routers.  This is something I never knew was possible until after making a few phone calls to Cisco.  Using bridging saved our company money by not requiring us to purchase a new switch.  Bridgi…
In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

809 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question