Want to win a PS4? Go Premium and enter to win our High-Tech Treats giveaway. Enter to Win

x
?
Solved

Cisco 800 series password verification

Posted on 2008-06-11
2
Medium Priority
?
596 Views
Last Modified: 2008-06-11
Hi

I have just been given a 837 router and I get this message when tryin to configure it in hyperterminal

CCAuthorized access only!
 Disconnect IMMEDIATELY if you are not an authorized user!

User Access Verification

Password:

Is there a  way I can reset the password?
0
Comment
Question by:Dan560
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 16

Accepted Solution

by:
2PiFL earned 2000 total points
ID: 21758953
0
 
LVL 7

Expert Comment

by:logic2
ID: 21760742
is this a brand new router ?
try using cisco or mypassword  :) sometimes it works
0

Featured Post

[Webinar] Lessons on Recovering from Petya

Skyport is working hard to help customers recover from recent attacks, like the Petya worm. This work has brought to light some important lessons. New malware attacks like this can take down your entire environment. Learn from others mistakes on how to prevent Petya like worms.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

618 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question