Solved

Need some advice on replacing an existing router with a new one.

Posted on 2008-06-12
5
183 Views
Last Modified: 2010-04-21
The old router is a 1700 series router and the new one is a 1841 (both cisco).
Do I need to load any config besides the start-up config from the 1700 to the 1841 in order to replace the router?
0
Comment
Question by:bankadmin
  • 3
  • 2
5 Comments
 
LVL 43

Accepted Solution

by:
JFrederick29 earned 500 total points
Comment Utility
You may need to change the interface type and NAT statements that reference an interface but the rest should be okay.
0
 

Author Comment

by:bankadmin
Comment Utility
Ok.. I have downloaded config files to a ftp server before but I have not uploaded from ftp to router what commands do that?
0
 
LVL 43

Assisted Solution

by:JFrederick29
JFrederick29 earned 500 total points
Comment Utility
copy ftp start
0
 

Author Comment

by:bankadmin
Comment Utility
Thanks
0
 

Author Closing Comment

by:bankadmin
Comment Utility
THanks for the help it somewhat worked it copied over about half of the config
0

Featured Post

IT, Stop Being Called Into Every Meeting

Highfive is so simple that setting up every meeting room takes just minutes and every employee will be able to start or join a call from any room with ease. Never be called into a meeting just to get it started again. This is how video conferencing should work!

Join & Write a Comment

While it is possible to put two routes in place with the secondary having a higher metric, this may not always work. In the event of a failure that does not bring down the physical interface on the router the primary route is not removed. There is a…
I have seen some questions on problems with SSH/telnet access to Cisco routers that may occur despite the fact that from a PC connected to your LAN, Internet connectivity is in place and users can access Internet sites without any issues.  There are…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

772 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

10 Experts available now in Live!

Get 1:1 Help Now