Solved

How to manage FastEthernet port of NME-16ES-1G-P on Cisco ISR 3825

Posted on 2008-06-16
4
1,685 Views
Last Modified: 2008-07-08
Hell!
I have to set up Cisco ISR 3825 in my office but I do not know how to manage NME-16ES-1G-P card on it.
Please assist me how to get in FastEthernet pot manage configuration mode.

koku10
0
Comment
Question by:koku10
  • 2
  • 2
4 Comments
 
LVL 50

Expert Comment

by:Don Johnston
ID: 21798657
From config mode,

interface "fastethernet slot/0/port" or "gigabitethernet slot/0/port".

So if the card is in slot 1 and you want to configure the fastethernet port 3, the command would be

int fa1/0/3
0
 

Author Comment

by:koku10
ID: 21798851
Hi, donjohnston.

The card(NME-16ES-1G-P) is on Network module slot 1, then I tried follows but did not work.
Router#
Router#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#interface gigabitEthernet 1/0/1
                                                   ^
% Invalid input detected at '^' marker.

I think, once I get switch config mode, prompt will be changed from Router# to switch#. and there is key input like Ctrl + Alt then prees ??? key. Or there is config command to get into switch config mode I think, I could managed before but foreget what was it.

Thank you,
koku10


0
 
LVL 50

Expert Comment

by:Don Johnston
ID: 21798966
0
 

Accepted Solution

by:
koku10 earned 0 total points
ID: 21800215
The link you provide me show exactly what I wanted.
Thank you
0

Featured Post

Is Your Active Directory as Secure as You Think?

More than 75% of all records are compromised because of the loss or theft of a privileged credential. Experts have been exploring Active Directory infrastructure to identify key threats and establish best practices for keeping data safe. Attend this month’s webinar to learn more.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
server can't ping default gateway 25 113
Systems talking to each other 5 123
VirtualBOX on GNS3 11 93
Do you think below two ipv6 routes are the same thing? 4 29
Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
Getting hacked is no longer a matter or "if you get hacked" — the 2016 cyber threat landscape is now titled "when you get hacked." When it happens — will you be proactive, or reactive?
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

932 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

13 Experts available now in Live!

Get 1:1 Help Now