Solved

First time to set up this type of router.

Posted on 2008-06-17
3
294 Views
Last Modified: 2008-07-02
Although I have set up multiple routers in the past, they have all been hooked to a line that needed termination for example a T1.  I would set up the serial connection with my IP then give my internal interface a public IP and then use my PIX as my first internal IP and gateway through it to the router.  I have switched ISP's and we are using a wireless connection.  The ISP basically handed me CAT5.  I am setting p the router as well as a new ASA appliance and could use some help with the configuration.  I have a block of public IP addys but do I assign a private to the internal interface then send my ASA to that?  So I still gateway through my ASA?

Ron
0
Comment
Question by:Ronster_1
  • 2
3 Comments
 
LVL 5

Expert Comment

by:Melaleuca
ID: 21804888
If they are handing off to you in Ethernet i would say you don't need the router and plug directly into your ASA.
0
 

Author Comment

by:Ronster_1
ID: 21810017
Well I thought about a layer 2 switch instead of the router but need the room for growth.  I have the router running and will do the ASA tomorrow.  Seems to be not such a big deal.

Ronster
0
 

Accepted Solution

by:
Ronster_1 earned 0 total points
ID: 21857457
OK  

I did it all.  Through the router and the to ASA.  All is working as should be.
0

Featured Post

VMware Disaster Recovery and Data Protection

In this expert guide, you’ll learn about the components of a Modern Data Center. You will use cases for the value-added capabilities of Veeam®, including combining backup and replication for VMware disaster recovery and using replication for data center migration.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

I recently updated from an old PIX platform to the new ASA platform.  While upgrading, I was tremendously confused about how the VPN and AnyConnect licensing works.  It turns out that the ASA has 3 different VPN licensing schemes. "site-to-site" …
How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

920 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question

Need Help in Real-Time?

Connect with top rated Experts

18 Experts available now in Live!

Get 1:1 Help Now