Go Premium for a chance to win a PS4. Enter to Win

x
?
Solved

Configure Linksys WRV200 for Multiple VPN Users

Posted on 2008-06-18
3
Medium Priority
?
1,038 Views
Last Modified: 2009-12-16
We are using Cisco Systems VPN client (ver 4.8.0) to establish VPN connections to our data center.  End users use a mix of Macs and PCs.

At one location, we have a Linksys WRV 200.  One user connects wirelessly, another is a wired connection.  The users have their own VPN accounts.  When one connects, the other is disconnected.  We can have both connected to the VPN when we don't use the router, so I am confident that the router is just mis-configured.

However, the only instructions I can find seem to pertain to the Quick VPN feature.  I don't think I need this - we already have VPN client software (which I do not want to change - I'd prefer to stay consistent across locations).  I have also seen instructions for configuring a VPN tunnel - again, not an issue: when one user is on, the connection is fine.  It's just the presence of the second connection that seems to create a problem.

I have spent about two hours on hold with Linksys support, and am now searching for other resources!  Any suggestions ... ?

Thank you.
0
Comment
Question by:anncb
2 Comments
 

Accepted Solution

by:
anncb earned 0 total points
ID: 21823484
I have resolved this.  Solution, for anyone who is interested:

1) Upgrade firmware (1.0.39) on router
2) Set port access (for Cisco: 500, 1000, 1024, 512)
3) Enable Mac cloning
4) Turn off multi-cast (under Firewall)
0
 
LVL 44

Expert Comment

by:Darr247
ID: 21827211
You can accept your own answer as the solution.
Premium members get unlimited points to use for questions, so what happens to those shouldn't really matter.
0

Featured Post

How to Use the Help Bell

Need to boost the visibility of your question for solutions? Use the Experts Exchange Help Bell to confirm priority levels and contact subject-matter experts for question attention.  Check out this how-to article for more information.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

How to set-up an On Demand, IPSec, Site to SIte, VPN from a Draytek Vigor Router to a Cyberoam UTM Appliance. A concise guide to the settings required on both devices
If you’re involved with your company’s wide area network (WAN), you’ve probably heard about SD-WANs. They’re the “boy wonder” of networking, ostensibly allowing companies to replace expensive MPLS lines with low-cost Internet access. But, are they …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…

876 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question