Solved

Policy Routing and VPN Users

Posted on 2008-06-19
2
333 Views
Last Modified: 2010-04-21
This is a followup to this question: http://www.experts-exchange.com/Hardware/Networking_Hardware/Routers/Q_23498758.html

My problem is after setting up some custom routes based on the source IP I am having some issues with VPN users not being able to connecting to anything other than what is listed in the ACLs that I am using for my custom routes. Once connected they are able to get to any of the the nodes that have an IP in one of the ACLs but they are unable to reach any internal IP that is not part of the ACL. This is the case with or without the acces-list I thought I needed for VPN users (access-list 10 permit 10.0.50.0 0.0.0.255).
0
Comment
Question by:icarus004
2 Comments
 
LVL 43

Accepted Solution

by:
JFrederick29 earned 500 total points
ID: 21824206
I assume the 3600 LAN/WAN router is where you are applying the policy routing, right?  If so, you should only need to simply add a route to the 3600 pointing to the PIX for the VPN subnet.

conf t
ip route 10.0.50.0 255.255.255.0 10.0.2.8
0
 
LVL 2

Author Closing Comment

by:icarus004
ID: 31468889
That did it. Thanks.
0

Featured Post

Efficient way to get backups off site to Azure

This user guide provides instructions on how to deploy and configure both a StoneFly Scale Out NAS Enterprise Cloud Drive virtual machine and Veeam Cloud Connect in the Microsoft Azure Cloud.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Title # Comments Views Activity
ACL Logging Optimization 7 41
Problem to router 7 54
Open Port Forwarding but still can't connect RDP 9 46
VLAN Overused monitor 4 15
There are two basic ways to configure a static route for Cisco IOS devices. I've written this article to highlight a case study comparing the configuration of a static route using the next-hop IP and the configuration of a static route using an outg…
In the world of WAN, QoS is a pretty important topic for most, if not all, networks. Some WAN technologies have QoS mechanisms built in, but others, such as some L2 WAN's, don't have QoS control in the provider cloud.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
As a trusted technology advisor to your customers you are likely getting the daily question of, ‘should I put this in the cloud?’ As customer demands for cloud services increases, companies will see a shift from traditional buying patterns to new…

773 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question