vpn to ASA5100 show down and ghost interface appears NVI1

Posted on 2008-06-20
Medium Priority
Last Modified: 2012-05-05
I have a 871W which is behaving strangely.

1) NVI1 is not in the config but it appears in output of sh int br with same ip as FastEthernet4

Synergy-SC#show ip int br
Interface                  IP-Address      OK? Method Status                Prot
FastEthernet0              unassigned      YES unset  up                    up

FastEthernet1              unassigned      YES unset  up                    down

FastEthernet2              unassigned      YES unset  up                    down

FastEthernet3              unassigned      YES unset  up                    down

FastEthernet4       YES NVRAM  up                    up

Dot11Radio0                unassigned      YES NVRAM  up                    up

Dot11Radio0.1              unassigned      YES unset  up                    up

Dot11Radio0.2              unassigned      YES unset  up                    up

Dot11Radio0.3              unassigned      YES unset  up                    up

Vlan1                      unassigned      YES NVRAM  up                    up

NVI0                YES unset  up                    up

BVI1                YES NVRAM  up                    up
Question by:hotchkissj
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
1 Comment
LVL 79

Accepted Solution

lrmoore earned 1500 total points
ID: 21837470
The NAT Virtual Interface (NVI) feature, is identified by the addition of an ip nat enable configuration to interfaces that apply NAT or PAT.

Featured Post

On Demand Webinar: Networking for the Cloud Era

Ready to improve network connectivity? Watch this webinar to learn how SD-WANs and a one-click instant connect tool can boost provisions, deployment, and management of your cloud connection.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

In the hope of saving someone else's sanity... About a year ago we bought a Cisco 1921 router with two ADSL/VDSL EHWIC cards to load balance local network traffic over the two broadband lines we have, but we couldn't get the routing to work consi…
Creating an OSPF network that automatically (dynamically) reroutes network traffic over other connections to prevent network downtime.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Windows 10 is mostly good. However the one thing that annoys me is how many clicks you have to do to dial a VPN connection. You have to go to settings from the start menu, (2 clicks), Network and Internet (1 click), Click VPN (another click) then fi…
Suggested Courses

765 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question