Solved

Cisco Console Messages

Posted on 2008-06-26
2
407 Views
Last Modified: 2010-04-12
I am setting up a VTP domain name to work with VLAns. When i tye VTP  and a ? it comes up with

CBTSwitch2(config)#vtp ?
  file  Configure IFS filesystem file where VTP configuration is stored.

the switches I am using are: cisco WS-C2924M-XL and   WS-C2924-X.

I have done a bit of reseach and it says i must creat a file i did

"CBTswitch1(config)#vtp file VTPconfig"

and it gave me this error

"Operation failed; unable to read old configuration."

What am i doing wrong?
0
Comment
Question by:aquahays
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
2 Comments
 

Author Comment

by:aquahays
ID: 21874749
I have added a bit more to the question
0
 

Accepted Solution

by:
aquahays earned 0 total points
ID: 21879255
I have found the reason. Refererenc to Donjonston answer
0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Did you know SD-WANs can improve network connectivity? Check out this webinar to learn how an SD-WAN simplified, one-click tool can help you migrate and manage data in the cloud.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

729 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question