fbrsupport
asked on
Ghost not mounting hard drive with error "Invalid Destination Drive"
Hello,
I am trying to image an HP xw6600 using a script made through LANDesk (a workstation management tool). LANDesk executes a script that uses Ghost 11 as it's imaging tool.
When trying to image, Ghost gives the error "Invalid Destination Drive". Here are the troubleshooting steps I took:
- from a command prompt, ran "diskpart", "list partition", "list disk" and "list volume" commands, no volumes partitions or disks were found
- went into the BIOS and made sure the HD was detected, and it was
- booted up the pc normally to see if the existing OS will load, it did
- swapped out the HD with a known good one, still got same error
- used the same LANDesk script to image another PC of a different model, that worked fine
Attached is the GHOSTERR.TXT file that was generated. I know for a fact that LANDesk adds this line to it
"Command line arguments: -clone,mode=load,src=i:\#N EW#\DESKTO P\WXP3UIU. GHO,dst=1 -noIDE -fni -ffx -sure -auto"
Anyone have any ideas?
thanks!
Mark
GHOSTERR.TXT
I am trying to image an HP xw6600 using a script made through LANDesk (a workstation management tool). LANDesk executes a script that uses Ghost 11 as it's imaging tool.
When trying to image, Ghost gives the error "Invalid Destination Drive". Here are the troubleshooting steps I took:
- from a command prompt, ran "diskpart", "list partition", "list disk" and "list volume" commands, no volumes partitions or disks were found
- went into the BIOS and made sure the HD was detected, and it was
- booted up the pc normally to see if the existing OS will load, it did
- swapped out the HD with a known good one, still got same error
- used the same LANDesk script to image another PC of a different model, that worked fine
Attached is the GHOSTERR.TXT file that was generated. I know for a fact that LANDesk adds this line to it
"Command line arguments: -clone,mode=load,src=i:\#N
Anyone have any ideas?
thanks!
Mark
GHOSTERR.TXT
ASKER CERTIFIED SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
SOLUTION
membership
This solution is only available to members.
To access this solution, you must be a member of Experts Exchange.
ASKER
thanks!