We help IT Professionals succeed at work.
Get Started

Surf Control will not work

Last Modified: 2010-05-18
Ever since we installed 2 new 48 port Cisco Catalyst 3750 switches we cannot get Surf Control to work properly, I think it may be the span port setup in the switch,  it does not block anything, here is what it looks like in our switch:

*We have port 47 as the Destination Port, and port 48 is our source port which is uplinked to our firewall.

interface GigabitEthernet2/0/47
 switchport trunk encapsulation dot1q
interface GigabitEthernet2/0/48
 description Uplink to ASA5510
 no switchport
 ip address
 speed 100
 spanning-tree portfast

*Then we have the monitor session commands designating which port is source and destination.

monitor session 1 source interface Gi2/0/48
monitor session 1 destination interface Gi2/0/47

I can't find any other person that has theirs setup differently, is there anything else that should be entered into the switch to make it work? or is there something I should  double check on the Surf Control server itself (which is Server 2003 R2 SP2)?

Thanks ahead of time guys!!
Watch Question
This problem has been solved!
Unlock 1 Answer and 7 Comments.
See Answer
Why Experts Exchange?

Experts Exchange always has the answer, or at the least points me in the correct direction! It is like having another employee that is extremely experienced.

Jim Murphy
Programmer at Smart IT Solutions

When asked, what has been your best career decision?

Deciding to stick with EE.

Mohamed Asif
Technical Department Head

Being involved with EE helped me to grow personally and professionally.

Carl Webster
CTP, Sr Infrastructure Consultant
Ask ANY Question

Connect with Certified Experts to gain insight and support on specific technology challenges including:

  • Troubleshooting
  • Research
  • Professional Opinions
Did You Know?

We've partnered with two important charities to provide clean water and computer science education to those who need it most. READ MORE