asked on
Trunk to Cat5500 not working
Trying to connect a new 2960 to the Cat-5
I have a trunk port on the cat-5 connected via x-over to G0/1 on new switch
2960 Config is
!
vlan internal allocation policy ascending
!
interface GigabitEthernet0/1
switchport trunk native vlan 100
switchport trunk allowed vlan 1-1005
switchport mode trunk
spanning-tree bpdufilter enable
The port on cat-5 is showing up/up (set trunk 12/9 on dot1q 1-1005, also vlan 100) but vlan 100 on 2960 is down any ideas?
I have another 2960 (older) with almost identical config that is working fine.
I have a trunk port on the cat-5 connected via x-over to G0/1 on new switch
2960 Config is
!
vlan internal allocation policy ascending
!
interface GigabitEthernet0/1
switchport trunk native vlan 100
switchport trunk allowed vlan 1-1005
switchport mode trunk
spanning-tree bpdufilter enable
The port on cat-5 is showing up/up (set trunk 12/9 on dot1q 1-1005, also vlan 100) but vlan 100 on 2960 is down any ideas?
I have another 2960 (older) with almost identical config that is working fine.
Networking
Last Comment
ja1clark
Did you shutdown vlan 1 on the 2960?
interface vlan 1
shutdown
interface vlan 1
shutdown
ASKER CERTIFIED SOLUTION
THIS SOLUTION ONLY AVAILABLE TO MEMBERS.
View this solution by signing up for a free trial.
Members can start a 7-Day free trial and enjoy unlimited access to the platform.
interface Vlan100
ip address 10.1.1.5 255.255.255.0
no ip route-cache
!
ip default-gateway 10.1.1.1