asked on

Windows Server 2003 Licencing Question

Hi Guys

I have installed a Windows Server 2003 Enterprise . while I was in between installations , It asked me you want per seat license or per User , At that time i selcted per user License , however my Requiremetns were to set go for Per seat Licenses and then I complete the installations.

My Quyestions is that if there is a way out that i can change that to to per seat licenses , As i will make that server as a radius server and for that i need unlimited access to this server . Kindly let me know the way where i do not need to rebuild the whole server once again .

Regards

ASKER CERTIFIED SOLUTION

oBdA

membership

This solution is only available to members.

To access this solution, you must be a member of Experts Exchange.

Start Free Trial

annasad

ASKER

I am configuring This server to run IAS package under networking Tab , for Internet Authenticatio server , I dont think so that in that case i need to acquire CAL Licenses , but further to this , I am checking with my Distributer .
can you further help me in tihs , As no user would be acessing the server in real meaning , but just authenticaion , I even dont have to configure any user in my IAS ,Just i specify Access points , Who is associated with Radis server authentiation .

oBdA

Usually, any *authenticated* connection to a server requires a CAL. If you're only using Radius, you might want to check with your distributor or Microsoft about the correct licensing.