Solved

Connect PIX506e to Cisco 2800 port FE 0/1

Posted on 2008-10-01
3
494 Views
Last Modified: 2012-06-21
Iam having trouble with site to site VPN ( hardware used 2 x PIX 506e ) after removing a 5 port Linksys workgroup switch from the Cisco 2800 series router that was connected to the cisco router via straight through cable and had a straight through cable running from it to the pix. Everything was working fine except very slow internet because of the switch. Now the PIX 506e had to be connected to the cisco 2800 series router to port FE 0/1 via a crossover cable to relieve the bottleneck by getting rid of the workgroup switch. Unfortunately that was the only way to get connectivity between the Cisco router 2800 and the PIX 506e.
Any ideas why a crossover would kill a previously working site to site vpn ?
0
Comment
Question by:protongeek
  • 2
3 Comments
 
LVL 20

Expert Comment

by:RPPreacher
ID: 22618866
Make sure the speed duplex on both ports match.
0
 

Author Comment

by:protongeek
ID: 22618896
We do have internet traffic though. Would this affect VPN traffic?
0
 
LVL 20

Accepted Solution

by:
RPPreacher earned 500 total points
ID: 22619046
Packet drops from duplexing errors would slow down internet but could make VPN stop working entirely.
0

Featured Post

PRTG Network Monitor: Intuitive Network Monitoring

Network Monitoring is essential to ensure that computer systems and network devices are running. Use PRTG to monitor LANs, servers, websites, applications and devices, bandwidth, virtual environments, remote systems, IoT, and many more. PRTG is easy to set up & use.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Suggested Solutions

Tired of waiting for your show or movie to load?  Are buffering issues a constant problem with your internet connection?  Check this article out to see if these simple adjustments are the solution for you.
Quality of Service (QoS) options are nearly endless when it comes to networks today. This article is merely one example of how it can be handled in a hub-n-spoke design using a 3-tier configuration.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…

792 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question