Solved

cisco 3560

Posted on 2008-10-01
2
235 Views
Last Modified: 2012-05-05
i have a cisco 3560 switch that has voip vlan. i am trying to modify this statement:
 monitor session 1 source vlan 4
I need to add " both "  after this command
i did config t
 monitor session 1 source vlan 4 both....does not work.
help
0
Comment
Question by:jeffsteffy
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
  • 2
2 Comments
 
LVL 12

Expert Comment

by:Pugglewuggle
ID: 22620071
Here is a Cisco document talking about setting up SPAN on a 3560. I hope this helps!
http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015c612.shtml#topic5 
0
 
LVL 12

Accepted Solution

by:
Pugglewuggle earned 500 total points
ID: 22620096
Here's is one specifically for the 3560:
http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.1_19_ea1/configuration/guide/swspan.html#wp1036829
Your command should work. Try doing a "no" command to clear your current monitor session and make new one. Please note that you CANNOT have more than 2 active SPANs on a switch.
Here is the answer to your question - in the 3560 the "both" keyword is not required. If not otherwise specified, the SPAN session will monitor both by default.
So, your command to use would be:
monitor session 1 source vlan 4
Cheers! I hope that answers your questions!
0

Featured Post

Optimum High-Definition Video Viewing and Control

The ATEN VM0404HA 4x4 4K HDMI Matrix Switch supports 4K resolutions of UHD (3840 x 2160) and DCI (4096 x 2160) with refresh rates of 30 Hz (4:4:4) and 60 Hz (4:2:0). It is ideal for applications where the routing of 4K digital signals is required.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

WARNING:   If you follow the instructions here, you will wipe out your VTP and VLAN configurations.  Make sure you have backed up your switch!!! I recently had some issues with a few low-end Cisco routers (RV325) and I opened a case with Cisco TA…
Let’s face it: one of the reasons your organization chose a SaaS solution (whether Microsoft Dynamics 365, Netsuite or SAP) is that it is subscription-based. The upkeep is done. Or so you think.
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
As a trusted technology advisor to your customers you are likely getting the daily question of, ‘should I put this in the cloud?’ As customer demands for cloud services increases, companies will see a shift from traditional buying patterns to new…
Suggested Courses
Course of the Month4 days, 11 hours left to enroll

635 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question