[2 days left] What’s wrong with your cloud strategy? Learn why multicloud solutions matter with Nimble Storage.Register Now

x
?
Solved

Policy Based Routing?

Posted on 2008-10-06
2
Medium Priority
?
565 Views
Last Modified: 2010-04-21
Hello,

I currently have a class B network and have the following routing setup on my Cisco 3750G

ip route 0.0.0.0 0.0.0.0 10.10.1.7
ip route 10.11.1.0 255.255.255.0 10.100.1.1 permanent
ip route 10.12.1.0 255.255.255.0 10.100.1.1 permanent
ip route 10.13.0.0 255.255.0.0 10.10.1.4 permanent


I would like to modify the above routing and make it so that any ip 10.10.1.x routes to 10.10.1.4 as their default while maintaining my default route to 10.10.1.7 for every other IP

I'm sure I'd have to setup some access rules, etc, but really am not sure what to do. Anyone know what to do?

Thanks!
Andy
0
Comment
Question by:andyvm
[X]
Welcome to Experts Exchange

Add your voice to the tech community where 5M+ people just like you are talking about what matters.

  • Help others & share knowledge
  • Earn cash & points
  • Learn & ask questions
2 Comments
 
LVL 79

Accepted Solution

by:
lrmoore earned 500 total points
ID: 22650957
access-list 101 permit ip 10.10.1.0 0.0.0.255 any
route-map MYMAP permit 10
 match ip address 101
 set ip next-hop 10.10.1.4

Apply the route map to the 10.10.1.x vlan interface

interface vlan xx
 ip policy route-map MYMAP

You might not have the Enhanced IOS image to use the policy routing, so it may not work unless you upgrade.
0
 

Author Closing Comment

by:andyvm
ID: 31503402
Great, thank you very much!
0

Featured Post

On Demand Webinar: Networking for the Cloud Era

Ready to improve network connectivity? Watch this webinar to learn how SD-WANs and a one-click instant connect tool can boost provisions, deployment, and management of your cloud connection.

Question has a verified solution.

If you are experiencing a similar issue, please ask a related question

Hello , This is a short article on how would you go about enabling traceoptions on a Juniper router . Traceoptions are similar to Cisco debug commands but these traceoptions are implemented in Juniper networks router . The following demonstr…
We've been using the Cisco/Linksys RV042 for years as: - an internet Gateway - a site-to-site VPN device - a leased line site-to-site subnet-to-subnet interface (And, here I'm assuming that any RV0xx behaves the same way as an RV042.  So that's …
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
After creating this article (http://www.experts-exchange.com/articles/23699/Setup-Mikrotik-routers-with-OSPF.html), I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites…
Suggested Courses

649 members asked questions and received personalized solutions in the past 7 days.

Join the community of 500,000 technology professionals and ask your questions.

Join & Ask a Question